Mold and Inner Wall Inspection System
In some areas where humidity is high, mold growth and damage to walls and substructure can happen without detection. Health and human safety can also be at risk if it is not detected and remediated as soon as possible.
The Moldeye video system is being designed to allow video inspection of hidden areas normally not accessible for viewing. This can allow early detection of mold and fungus growth.
Though not all mold is dangerous, the environment which allows any mold growth can allow the growth of the dangerous types as well.. More information on the different types of mold are available here
| Image Sensor | 1/4" color CCD |
| Picture Elements | EIA/NTSC 510H x 492V |
| Horizontal Frequency | EIA/NTSC 15.734kHz |
| Vertical Frequency | EIA/NTSC 60Hz |
| Clock Frequency | EIA/NTSC 19.0699Mhz |
| Horizontal resolution | 380 Lines |
| Illumination | 0 Lux (with 4 LEDs) |
| Scanning System | 2:1 Interlace |
| Signal to Noise ratio | 52dB |
| Electronic Shutter Speed | 1/120,000 sec |
| Lens | Pin Hole 3.7mm f2.0 |
| Video Output | 1V pp 75 Ohms |
| Gamma | 0.45 |
| White Balance | Auto Tracing |
| Power Supply | 5V DC +/- 0.5V @ 270ma |
| Weight | 85g |
| Dimensions(Length including cables) | Retracted 1800mm Extended 2800mm |
| Storage Temperature | -30°C to +60°C |
The Moldeye Inner wall inspection system consists of an extendable - retractable arm which ranges from 1.8 to 3 meters total length. On the end of the arm is a high performance 1/4" CCD camera with 4 bright white LED Illuminators. Optional Monitor is available as well.
The Camera is positionable because of a unique construction design allowing maximum flexibility for tight spaces where access is needed.
Replacement lenses are available at a nominal cost to Moldeye customers and can be shipped overnight if necessary
M-CM12L-1 - Includes Moldeye Wand with Positionable camera, and 5V DC Power supply
ALIGN="BOTTOM"> ">$695